National Item Identification Number
00-102-4297
001024297
3040-00-102-4297
3040001024297
National Stock Number
Item Name
SHAFT,SHOULDERED
Federal Supply Class
3040
Description
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (AA), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see AXLE(1), SHOULDERED. For items not having any of the above conditions see PIN, SHOULDER, HEADLESS. Excludes SHAFT(1), STRAIGHT; and AXLE(1), STRAIGHT.
Commercial and Government Entity Code (Supplier Data)
16236
24658
GENERAL REGULATOR CORP
DIV GENERAL REGULATOR DIVISION
517 PROSPECT ST
YORK
PA
17403
717-848-5960
Reference Numbers (Part Numbers)
CS3040-SR-0703
1797-34
Required Categories
MATERIAL
SURFACE FINISH
FIRST END STYLE
FIRST END GROOVE WIDTH
FIRST END GRO
Required Description
STEEL COMP 303
63.0 MICROINCHES
5 CIRCULAR GROOVED
0.1400 INCHES NOMINAL
0.2